officer  also  coordinates  with  the  electronics material officer to provide qualified personnel of other rates to conduct electrical safety training. Supply Officer —The supply officer ensures all electrical tools received aboard the command are turned over to the electrical tool issue room for a safety inspection before they are issued. The supply officer must ensure items received through open purchase or from SERVMART comply with that requirement. Division Officers —Division officers ensure assigned  personnel  are  trained,  that  training records are maintained, and that electrical equip- ment tools are properly maintained. They ensure portable electrical equipment, such as vacuum cleaners, buffers, and coffeepots, are electrically checked at proper time intervals. They also ensure portable electrical tools drawn from the portable electrical tool issue room are returned at the end of each workday. Medical Department —The medical depart- ment ensures that electrical first aid training, especially cardiopulmonary resuscitation (CPR), is provided to divisions when requested. Electrical Safety Petty Officer —The elec- trical safety petty officer works for the electrical safety officer. Before a person can be assigned as an electrical safety petty officer, he or she must meet the following qualifications: —Complete  a  basic  electrical/electronics school or equivalent training —Be fully qualified in personnel qualification standards (PQS) as ship’s maintenance and material management (3-M) (NAVEDTRA 43241E) watch station (301) maintenance personnel —Be fully qualified in PQS as a division safety petty officer/electrical safety petty officer (NAVEDTRA  43460-3A) Type commanders (TYCOMs) and the ship’s electrical safety instructions can provide additional information about the Electrical Safety Program and your responsibilities. Electrical safety is the responsibility of all hands. All Navy members must request permission from their division officer to bring personal electrical/electronic   equipment   aboard.   This equipment must be safety inspected. Program Elements The Electrical Safety Program consists of the following seven elements: Proper installation, maintenance, and repair of electrical equipment Routine and periodic testing to detect and correct unsafe equipment Setting of portable electrical standards Setting of electrical safety standards Training Proper use of equipment tag-out procedures Control  and  safety  testing  of  personal electrical/electronic  equipment ELECTRICAL  HAZARDS AND PRECAUTIONS Recognizing a hazardous condition and taking immediate steps to correct it is important. Safety posters (fig. 6-1 1) help warn of dangers in working areas or remind personnel to be safety conscious. Warnings signs (red) and caution signs (yellow) should be located where hazardous conditions exist. Be aware of areas that are wet or oily or have stumbling hazards. Wear rubber gloves and protective clothing wherever working conditions warrant it. Make it a habit to look for and to correct defective tools and equipment, improper grounding, and rotating machinery hazards. Handtools Normally, you should have no problems when working with handtools. In all likelihood, however, you have seen some dangerous practices in the use of handtools that should have been avoided. One unsafe practice involves the use of tools with plastic or wooden handles that are cracked, chipped, splintered, broken, or other- wise unserviceable. This practice is sure to result in accidents and personal injuries, such as cuts, bruises,  and  foreign  objects  being  thrown  in the  eyes.  If  unserviceable  handtools  are  not repairable, they should be discarded and replaced. When necessary (in an emergency only) to improvise an insulated handtool, use the following approved method to protect the user against the 6-22